Filter
Top Products
Problem solving guide
Any work done on the electrical components of this appliance should only
be performed by a qualified technician in accordance with all local and na
-
tional codes and regulations. Unauthorized repairs may result in personal
injury and machine damage.
What to do if,... Cause . . . Remedy . . .
. . . The program does
not start?
There is no power.
The “ON” indicator lamp
has not lit up.
Check that..:
–
the door is properly
closed.
–
the machine is plugged
in.
–
the fuse or circuit
breaker has not trip-
ped.
There is power and the
“ON” indicator lamp is on,
but the program selector
has not been turned to
the “Finish / Start” posi-
tion.
– Turn the program se-
lector to the “Finish /
Start” position.
– Select a program.
. . . The “Check
/ ”
indicator lamps are
flashing?
The “Check p” indicator
lamp is flashing, and the
program has started.
The water inlet is blocked.
– The inlet valve is not
opened far enough.
–
The inlet hose is
kinked.
–
The water pressure is
too low. Call the Techni
-
cal Service Dept.
The “Check q” indicator
lamp is flashing.
The drain is blocked.
–
Clean the drain pump
and lint trap.
–
Has the drain hose
been installed too
high? (max drain height
= 4 feet)
25
Problem solving guide