Filter
Top Products
What to do, if . . . Cause . . . Remedy . . .
. . . the “Water inlet" check
light flashes during the pro-
gramme but the programme is
running normally.
The water inlet is restricted.
– The stopcock is not opened
far enough.
– the inlet hose is kinked.
– the water pressure is too low
– the filter in the inlet hose is
dirty. Clean it.
. . . the “Water inlet" check
light flashes , the buzzer
sounds continuously and the
laundry was not washed.
The water inlet is blocked.
– Open the stopcock.
– Start the programme again.
. . . The “Water inlet" and
"Check drain" lights flash,
and the buzzer sounds con-
tinuously.
The Waterproof System has
reacted.
Call the Service department.
. . . one of the following indi-
cator lights is flashing
–“Soak/Pre-wash” + buzzer
–“Wash”
–“Rinse” + buzzer
–“Rinse hold”
There is a fault.
– Press “I-ON/0-OFF” button to
release.
– Turn the programme selector
to "Finish".
– Press “I-ON/0-OFF”.
– Re-start the programme.
– If the control light starts
flashing again, call the
Service dept.
. . . the wash programme fin-
ishes prematurely and three
horizontal dashes “– – –” ap-
pear in the display and the
buzzer sounds continuously.
There is a fault.
– Press “I-ON/0-OFF” button to
release.
– Turn the programme selector
to "Finish".
– Press “I-ON/0-OFF” button.
– Re-start the programme.
– If the three horizontal dashes
reappear call the Service
Dept.
Problem solving guide
41