Filter
Top Products
Leveling the washer
To ensure smooth operation the washer
must be level.
Failure to level the machine can result
in increased water and energy
consumption as well as the washer
"banging" in the spin cycle or "walking"
across the floor during use.
Adjust the four leveling feet
The washer is leveled by adjusting the
four feet. The machine is boxed with the
feet completely screwed in.
^
Turn the locking ring, 2, counter
-
clockwise with the enclosed
combination wrench. Unscrew the
each of the for feet as much as
needed by turning both the foot, 1,
and locking ring, 2, to the left.
^ Check that the machine stands level.
^ Once level, hold the foot, 1, immobile
with a wrench. Turn the locking ring,
2, with the combination wrench
towards the machine.
,
All four locking rings must be
tight against the bottom of the
machine. In addition, check to see
that the feet were not inadvertently
unscrewed while tightening the
rings. Running a machine that is not
level or whose feet are not tight may
cause damage to both the machine
and its surrounding area.
Installation
45