Filter
Top Products
With the help of the following notes, minor faults in the performance of the
appliance, some of which may result from incorrect operation, can be put right
without contacting the Service Department.
,
Repair work to electrical appliances should only be carried out by a
suitably qualified person in strict accordance with current local and national
safety regulations. Repairs and other work by unqualified persons could be
dangerous. The manufacturer cannot be held liable for unauthorised work.
Check and fault messages
Problem Possible cause Remedy
The programme stops
and 0 and Finish appear
in the display.
The buzzer sounds.
This is not a fault.
The electronic unit has
recognised that there is
no laundry in the drum
and cancelled the
programme.
Drying individual
garments or items which
are already dry can also
cause the programme to
be cancelled.
–
Use the Warm air
programme (timed
drying) to dry individual
items.
To delete the fault
message:
– Open and close the
door.
The Low temperature
indicator light starts
flashing after the dryer
has been switched on
and 0-§ appears in the
display.
The electronic system
lock is activated.
You will need to
deactivate the system
lock before the dryer can
be used (see "Electronic
system lock").
The programme stops
and Cooling down or
Finish flashes in the
display.
The buzzer sounds.
No obvious cause.
–
Switch the dryer off
and then on again.
–
Then start the
programme again.
If the programme stops
again and Cooling down
or Finish flashes again
there is a fault. Contact
the Miele Service
Department.
Problem solving guide
28