Filter
Top Products
F Starting a programme
^
Press the
Start
button.
The drying cycle begins.
The drying stage reached is shown by
the sequence indicator lamps on the
right hand side of the control panel.
At the end of the drying phase, a
cooling down phase commences to
cool the laundry down (the
Cool air
indicator lamp lights up).
The drying level required has now been
reached.
G After drying
The
Anti-crease/Finish
and the drying
stage reached indicator lamps light up.
The buzzer will sound at intervals
during the anti-crease phase if it has
been selected.
0 will then appear in the display.
^ Press the
Door
button to open the
drum door.
^
Remove the laundry.
Make sure that the drum is empty. If
items are left in the dryer, they could
be damaged by overdrying when
the dryer is next used.
^
After every cycle remove the fluff
from the fluff filter in the door and in
the door opening (see "Cleaning and
Care").
^
Empty the condensed water
container (where there is no external
drainage of the water).
^
The condenser unit should be
checked an cleaned on a regular
basis.
See "Cleaning and Care".
^
After each use, switch the dryer off
by pressing the
l-On / 0-Off
button.
^
Always close the door after use.
Additional notes
. . . Clean out airways indicator lamp
This indicator lamp comes on to warn
you that the dryer is not working
efficiently.
This may be because:
– the fluff filters are clogged;
– the condenser unit is clogged.
How to dry correctly
17