Filter
Top Products
Buzzer
The buzzer has two volumes.
Normal
(Factory default)
The buzzer sounds at the end of a
programme.
Loud
The buzzer sounds at maximum volume
at the end of a programme.
A tick L will appear beside the option
to show that it has been set.
Keypad tone
An audible tone sounds each time a
button is pressed.
A tick L will appear beside the option
to show that it has been set.
Factory default: Off.
Contrast
Brightness
There are ten different display
contrast and display brightness
settings.
The bar chart shows you the setting.
Factory default: a medium setting.
Standby display
To save energy, the display goes out
after 10 minutes and the indicator
light for the Start/Stop button will start
flashing slowly.
There are two options:
On
Standby is activated:
–
if a programme is not selected within
10 minutes of the tumble dryer being
switched on.
–
10 minutes after a programme has
started.
–
10 minutes after the end of a
programme.
Not in current prog.
(Factory default)
– Standby is activated if a programme
is not selected within 10 minutes of
the tumble dryer being switched on
and after the end of a programme.
(Standby is not activated after a
programme has started).
Pressing one of the buttons switches
the display back on again.
A tick L will appear beside the option
to show that it has been set.
Memory
The electronics will memorise the
drying level and any extra options
selected for the current drying
programme.
A tick L will appear beside the option
to show that it has been set.
Factory default: Off.
Settings menu J
54