Filter
Top Products
6. Throw out any excess water after use, once the
iron has been unplugged.
Steam Ironing
1. Fill up the iron as described in the section “How to
fill the water deposit”.
2. Plug in the iron.
3. Steam ironing is only possible if you select the
highest temperature***. Otherwise water may
seep through the base of the iron.
4. Wait for the pilot light to go off.
5. Turn the steam regulator to the desired position
6. During pauses and when the ironing is complete,
leave the iron standing upright.
7. Unplug the iron by pulling the plug out of the
socket. Pour out any leftover water and let the iron
cool down.
Spray
1. The spray can be used when dry ironing or when
steam ironing.
2. To do so, press the spray button. The spray button
has to be pressed repeatedly to release the first
spray.
Steam blast
The steam blast gives an extra steam jet to help
remove tough creases.
1. Select the maximum temperature*** on the
temperature gauge. Wait for the pilot light to go off.
2. Press the steam blast button. Wait a few seconds
for the steam to penetrate into the fabric before
pressing again. For optimum steam quality, do
not apply more than three successive blasts. The
spray button has to be pressed repeatedly to
release the first spray.
Cleaning and Maintenance
Cleaning
1. Unplug the appliance before proceeding to clean.
2. Do not use solvents or abrasive products for
cleaning. A damp cloth with a few drops of
washing up liquid is enough.
“Self-cleaning”
1. It is important to self-clean the appliance at least
once a month to remove calcium and any other
built-up minerals inside the iron.
2. Place the steam regulator control in the No
steam position.
3. Fill up the deposit to the top.
4. Stand the iron upright and plug it in.
5. Turn the temperature gauge to the *** position.
6. Let the iron heat up until the pilot light turns off and
back on again.
7. Unplug the iron and place it over the sink.
8. Press the self-cleaning button.
9. Let the water flow out through the steam vents in
the base whilst lightly shaking the iron.
10. Release the self-cleaning button after a moment
or when the deposit has been emptied
and place the iron in an upright position.
11. Let the iron cool and then clean it.
Maintenance
Any stains that may form on the base of the iron can
be cleaned off using a cloth dampened with water
and white vinegar.
Problems and Solutions
Should the mains connection fail, do not try to
replace it since this is potentially dangerous. Take the
appliance to an authorized Technical Support Service.
The same applies to any other type of problem. This
appliance complies with Low Voltage Directive 73/23/
EC and with Electromagnetic Compatibility Directive
89/336 EC.
SAVE THESE INTRUCTIONS
THIS PRODUCT IS FOR HOUSEHOLD USE
ONLY!
SERVICE
Before returning your product for service or repair –
check the following:
• Your household mains supply socket is working
properly.
• The mains supply circuit is not overloaded.
• The instructions for use have been followed
carefully.
If service becomes necessary within the guarantee
period the appliance should be returned to the retail
outlet where purchased or carefully packed and
marked “fragile-handle with care“ and sent carriage
paid to the address below. (Postage is not refundable)
Service outside the guarantee period is still available
but this will be chargeable.
_IM.indd 3 2013/08/13 11:51:13 AM