Filter
Top Products
13
The display will show the default settings for the selected
cycle. If desired, press the button beneath each setting to
adjust the Temperature, Soil Level, and Spin Speed, and to add
options such as an additional Rinse. Use the
and arrow
keys to page to additional options.
For more information on a cycle, press LEARN MORE.
NOTE: Not all settings are available on all cycles. See “Cycle
Guide” for available settings.
9. Adjust settings, if desired
10. Select any additional options
Press the FRESH HOLD button or STEAM FOR STAINS button
to add these options to the selected cycle.
If Fresh Hold is selected, the washer will automatically activate
the vent fan and tumble the load at the end of the wash cycle
for up to 16 hours. This is useful if you are unable to remove a
load immediately after the cycle has nished.
Steam for Stains can be used with most cycles to provide a
Steam boost for added cleaning power. See the “Cycle Guide”
for cycles that allow the Steam for Stains option.
NOTE: Not all options are available with all cycles or settings.
11. Setting a delayed start
If you do not want to begin a cycle immediately, you may
choose the DELAY START option. This will delay the start
of the wash cycle by up to 16 hours.
To set a Delay Start:
1. Select the Delay Start option using the LCD control buttons.
Use the
and buttons to increase or decrease the delay
time. Press OK to set the delay.
2. To begin the delay countdown, press START/PAUSE.
The delay countdown has started when the countdown
screen is displayed.
IMPORTANT: If you are using the Delay Wash option, use of the
dispenser cartridge is recommended, or powdered detergent
may be used in the HE powdered detergent compartment.
start
pause
press and
hold to start
12. Press and hold START/PAUSE
to begin wash cycle
Press and hold the START/PAUSE button to start the wash
cycle. To pause a cycle in progress, press the START/PAUSE
button once, then press and hold again to continue the cycle.
To cancel a cycle, press the POWER button.
Once you press and hold START/PAUSE, you will hear the
door lock, unlock, and lock again. The washer door will remain
locked during the wash cycle.
Unlocking the door to add garments:
If you need to open the door to add 1 or 2 missed garments,
you may do so while “Door Locked - To unlock and add a
garment, press START/PAUSE” is displayed.
Press START/PAUSE once; the door will unlock
once the washer movement has stopped.
This may take several minutes. Add the extra
garments and close the door. You must
press START/PAUSE to restart the cycle.
start
pause
press and
hold to start