Filter
Top Products
6
This dryer is supplied/fitted with an electricity supply cord and plug. It
should be connected to electricity supply socket at the voltage shown
on the rating plate. The minimum supply fuse capacity should be 5A.
The dryer must be positioned so that the plug is clearly visible and
accessible. This plug also provides the function of an emergency stop
controlforthe user. Ifthefittedplug is notused,theelectrical connection
must be carried outbya competent electricianin accordance with local
or national codes.
If the supply cord is damaged, it must be replaced with a specially
terminatedcord byan authorizedserviceagent or a similarly competent
person in order to avoid a hazard.
Do not use an adapter.
Do not use an extension cord.
NOTE: In accordancewith the European EMC Directive (2004/108/EC),
the maximum electricitysupplysystemimpedanceto which the gas
dryer shouldbe connected is declared to be 0.054 Ohm + j0.034Ohm.
NOTE:Electricalsafetystandards:Themanufacturerhaschosencompliance
with IEC/EN.60335 standards asthemostappropriateforthis product.
If codes permit and an additional earth bond wire is used, it is
recommended that a qualified electrician determine that the earth
bond path is adequate.
Gas Supply Requirements
EARTHING INSTRUCTIONS
SAVE THESE INSTRUCTIONS
IMPORTANT: Observe all governing codes and ordinances.
Gas Supply
Before installation, check that the local gas distribution
conditions, nature of gas and pressure, and the adjustment
of the appliance are compatible. Burner information will be
found on the model/serial rating plate in the door recess of
the dryer. If this information does not agree with the type
of gas available, see your dealer.
Using the universal cord included with this dryer:
The gas dryer is equipped with a universal cord with
interchangeable plugs.
1. To use the universal cord, select the plug end that fits
y
our electrical outlet, and plug it into the adapter on the
supply cord.
2. Secure the plug end in place on the cord by aligning
the 2 cover halves over the cord adapter and clipping
them together.