Filter
Top Products
4
INSTALLATION INSTRUCTIONS
Tools and Parts
Gather the required tools and parts before starting installation. Read and follow the
instructions provided with any tools listed here.
Parts supplied
Remove parts package from dryer drum. Check that all parts are included.
NOTE: Do not use leveling legs supplied with dryer if installing on a pedestal.
Parts needed
Check local codes. Check existing electrical supply and venting. See “Electrical
Requirements” and “Venting Requirements” before purchasing parts.
Mobile home installations require metal exhaust system hardware available for purchase from
the dealer from whom you purchased your dryer. For further information, please refer to the
“Assistance or Service” section.
Optional Pedestal
Are you placing the dryer on a pedestal? You have the option of purchasing pedestals of
different heights separately for this dryer. You may select a 10" (25.4 cm) or 15.5" (39.4 cm)
pedestal with drawer. The pedestal will add to the total height of the dryer for a total height
of approximately 48" (121.9 cm) or 53.5" (135.9 cm), respectively.
For a garage installation, you will need to place the 10" (25.4 cm) pedestal at least
9" (22.9 cm) above the floor. You will need to place the 15.5" (39.4 cm) pedestal at least
3.5" (8.9 cm) above the floor.
The pedestals are available in several colors. To order, call the dealer from whom you
purchased your dryer or refer to the “Assistance or Service” section.
Stack Kit
Are you planning to stack your washer and dryer? To do so, you will need to purchase a Stack
Kit. To order, call the dealer from whom you purchased your dryer or refer to the “Assistance
or Service” section. Ask for Part Number 8212640.
Door Reversal Kit
Are you planing to reverse the door swing direction on your PERFORMANCE SERIES dryer? To
do so, you will need to purchase a Door Reversal Kit.
To order, call the dealer from whom you purchased your dryer or refer to the “Assistance or
Service” section. Ask for Part Number W10200372.
Backguard
If you are installing your PERFORMANCE SERIES washer and dryer and wish to avoid having
loose items fall behind your machines, you may purchase a pair of washer/dryer backguards.
These will reduce the chance of items falling behind the machines during operation.
To order, call the dealer from whom you purchased your dryer or refer to the “Assistance or
Service” section. Ask for Part Number 8558694 (White).
Flat-blade screwdriver
#2 Phillips screwdriver
Adjustable wrench that opens to 1"
(2.5 cm) or hex-head socket wrench
(for adjusting dryer feet)
Wire stripper (direct wire installations)
Level
Vent clamps
Caulking gun and compound (for
installing new exhaust vent)
Tin snips (new vent installations)
¼" nut driver (recommended)
Tape measure
A.Leveling legs (4)
B.“Y” connector
C.Short inlet hose
D.Inlet hose with right-angle connector
E.Rubber washer
A
B
C
D
E
A.10" (25.4 cm) pedestal
B.15.5" (39.4 cm) pedestal
Pedestal Height Color Part Number
10" (25.4 cm) White MHP1000SQ
15.5" (39.4 cm) White XHP1550VW
15.5" (39.4 cm) Crimson XHP1550VF
15.5" (39.4 cm) Evergreen XHP1550VP
15.5" (39.4 cm) Oxide XHP1550VJ
AB