Filter
Top Products
26
NOTE: If computer program changes are required, refer to the computer programming section of the
manual supplied with the dryer.
6. The dryer should be operated through one (1) complete cycle to assure that no further adjustments are
necessary and that
ALL components are functioning properly.
BASKET (TUMBLER) COATING
The basket (tumbler) is treated with a protective coating. We suggest dampening old garments or cloth material
with a solution of water and nonflammable mild detergent and tumbling them in the basket (tumbler) to remove
this coating.
7. Check the electric service phase sequence (3-phase [3ø] models only). While the dryer is operating, check
to see if the blower wheel (impellor/fan) is rotating in the proper direction. Looking from the front, the
blower wheel (impellor/fan) should spin in the clockwise (CW) direction. If it is, the phasing is correct. If
the phasing is incorrect, reverse two (2) of the three (3) leads at connections L1, L2, and L3 of the power
supply to the dryer.
IMPORTANT: If the blower wheel (impellor/fan) is rotating in the wrong direction, it will drastically
reduce drying efficiency and it can also cause premature component failure.
J. PREOPERATIONAL INSTRUCTIONS
COIN MODELS
Microprocessor Controller (computer)
1. When the microprocessor controller (computer) is in the ready state, the liquid crystal display (L.C.D.)
screen will display Ready, Insert $XX.XX (amount) to Start.
2. Insert coin(s). Once the correct Amount To Start has been inserted, the L.C.D. will display Select
Temperature.
3. Select temperature by pressing HI, MED, or LO. The cycle will start and the L.C.D. will display the
Dry Cycle selected and the remaining time.
4. The dryer will continue through the drying and cooling cycles, until the vended time has expired.
NOTE: To stop dryer, open main door or pressing the pause key. Continuation of the cycle will
resume only after the door has been closed and any of the three (3) temperature selection is
pressed.
5. Upon completion of drying and cooling cycles, the tone (buzzer) will sound and the dryer will go into the
Anti-Wrinkle mode for 99 minutes, or until the main door has been opened.
IMPORTANT: For more detailed information regarding the microprocessor controller (computer) on
your dryer, refer to the microprocessor users manual included with the dryer.