Filter
Top Products
19
Break off tag A on the cup fitted on the right
side and tag B on the cup fitted on the left
side. Then remove the paper from the self-
adhesive surface under the plastic cups.
4. Fit the plastic cups so that the “tags”
marked with arrows are against the front
edge of the cover and side edge and press
firmly onto the cover. Then break off the
remaining tags.
5. Push the tumble dryer in under the metal
angles, keeping the front edge raised 1 - 2 cm.
6. Lower the tumble dryer’s front feet into
the plastic cups and adjust so that the dryer
is balanced.
Adjusting the feet
Screw the feet in or out so that the tumble
dryer is steady and balanced on the floor or
on the washing machine. Then tighten the
locking nuts.
Condensed water
The machine is supplied as shown in
Option 1 (inset). This means that the
condensed water is pumped into the con-
densed water container. This must then be
removed and emptied by hand.
Option 2 allows you to remove the small
short hose from the blue nipple. Then at-
tach the enclosed rubber hose to the blue
nipple. The water can then be pumped out
into a laundry sink or a floor drain (2a).
Locking nut
2
1
2a
Max.
1,000 mm
A
B