Filter
Top Products
10
7
1
2
Delayed Start
Select or deselect this option by pressing
the Delayed Start button. The machine will
start the programme 5 hours after you se-
lect this option + the Start/Stop button.
A lighted red field by the button indicates
that the option has been activated. If you
change your mind, press the Start/Stop but-
ton for three seconds. You can now start the
machine as usual
Press the Start button
Drying time remaining
An estimate of the remaining drying time
will be shown in the display within 2 min-
utes of the drying programme starting. For
example, 1:35 means that approximately 1
hour and 35 minutes remain until the load
achieves the selected level of dryness. If
the Anti-crease option has been selected,
the drum will rotate every minute for 2 hours
after cooling.
If you want to stop or change a
programme.
Press and hold the Start/Stop button for 3
seconds. The red field next to the button
goes out.
Note!
The programme is not affected if the pro-
gramme selector is changed after the pro-
gramme starts.
To load or remove washing
If you want to load or remove washing
once you have started the machine, open
the door and the machine will stop auto-
matically. Load more washing, close the
door and press the Start/Stop button.
6
Drying programme finished
The text in the display indicates
that the programme has finished.
If the Anti-crease option has been
selected, the drum will rotate every minute
for 2 hours after cooling.
Important!
• Clean the fluff filter after each load.
• Drain the condensed water container after
each load.
Caution!
If the fluff filter becomes clogged, the ma-
chine’s automatic overheating cut-out may
be triggered. To enable the machine to be
restarted, the filter must be cleaned and
the machine allowed to cool for around 30
minutes.
Cleaning the fluff filter
1. Grasp the filter handle and pull it towards
you.
2. Pull the filter out of its holder.
3. Open the filter and remove the fluff by
hand.
4. Fold the filter up and re-insert it into its
holder. The filter may need to be cleaned
if limescale deposits occur, see “Care and
cleaning” chapter.