Maytag MDE7550AGW Clothes Dryer User Manual


 
3
GETTING STARTED
LAUNDRY
To dry a load of laundry the following steps are taken. They are discussed in greater detail in later sections.
1. Clean the lint filter.
2. Load the dryer properly.
3. Add fabric softener sheet (if desired).
4. Set dryer programme.
TOUCHSCREEN
If there are no words on the touchscreen, open the door, touch any key (except OFF), or touch the screen to “wake” the controls.
The machine will beep three short beeps if an invalid key sequence is pressed.
Power Outage – If the machine is running during a power cut, the machine will go into “PAUSE” mode. When power returns, the
screen will display a power failure message. Press “OK” to continue.
sensor dry
Home
timed dry
freshen up
air fluff
(no heat)
favourites
crease removal
Touchscreen - An interactive display
that responds with the touch of a finger.
Note: Exposure of the touchscreen to
direct sunlight is not recommended.
Favourites - Quick
access to your
named cycles.
Start/Pause - Press this
pad to start a cycle. Once
started, pressing this pad
will stop the dryer at any
point in the cycle.
Help - Quick access to
Troubleshooting, Laundering
Hints, Operating Tips, Lock
Out and Select Preferences.
Back - Takes you to the
previous screen.
Home - Takes you
immediately to the
first screen.
Off - Stops the dryer
and turns off the display.
Special Note: As you use the touchscreen, if you feel you are lost, press Back or Home.