Maytag MD98 Clothes Dryer User Manual


 
10
Touch “more cycles” on the
Home screen.
Step 1
SETTING DRYEL
®
sensor dry
Home
time dry
more cycles
air fluff
(no heat)
favorites
“Dryel
®
” – Dryel
®
is a home dry cleaning kit. Your dryer offers a “Dryel
®
cycle to maximize the benefit of the kit.
Select “Dryel
®
.
Step 2
wrinkle release
freshen up
Dryel
®
More Cycles
Review Screen – The default settings for “Dryel
®
are
30 minutes of tumble using regular temperature heated
air. You may press Start/Pause to begin or select any of
the areas on the touchscreen to further customize the
“Dryel
®
cycle.
Step 3
dryel
30 minutes
regular
temperature
options
Press "Start/Pause" or
change your selection below.
Touch the up or down arrow to set the time
to tumble. The time will increase or decrease
by one minute increments. Press “continue”
when done.
dryel
30 min
Press "Start/Pause" or
change your selection below.
regular
temperature
options
Time
continue
30
minutes
To uch the appropriate
temperature for the load.
dryel
30 minutes
Press "Start/Pause" or
change your selection below.
regular
temperature
options
Temperature
regular medium
delicate
extra low
To uch the appropriate options
then press “continue”.
loud end of
cycle chime
continue
remind chime
on off
Options
For Best Performance:
• Refer to the Dryel
®
instructions for proper use.
• Items in the bag must tumble. Place no more than 3 to
4 items in the bag at one time.
• Do not mix colors or fabrics when using Dryel
®
.
• Immediately at the end of the cycle, remove garments
from the Dryel
®
bag. Hang the garments while still
warm and slightly damp to minimize wrinkles.
NOTES:
• Use ONLY the Dryel
®
fabric care product in your dryer.
• DO NOT use and place any flammable substances or
solvents in the dryer including but not limited to: Energine,
Goddard’s, lighter fluid,WD-40, and vegetable oil.
• Always check manufacturer’s instructions before using a
home dry cleaning product.
Touch the up or down arrow to
set the time to tumble. The time
will increase or decrease by one
minute increments. Press
“continue” when done.
freshen up
15 minutes
Press "Start/Pause" or
change your selection below.
extra low
temperature
options
Time
continue
15
minutes
To uch the appropriate
temperature for the load.
freshen up
15 minutes
Press "Start/Pause" or
change your selection below.
extra low
temperature
options
Temperature
regular medium
delicate
extra low
To uch the appropriate options then press “continue”.
loud end of
cycle chime
continue
remind chime
on off
Options