Filter
Top Products
Before You Call ...................................................
For problem laundry solutions (i;e.fabric damage, residue, tangling) and special laundry care
procedures, see the enclosed Laundry Tips pamphlet.
Check these )oints if your washer...
Always • Plug cord into live electrical outlet.
Check First • Check fuse or reset circuit breaker.
• • oleo*J1..* ,.....*.. *.....*...*... *,.. • .. .. .. ., .. ... .., ... ... ..,. ..,..• .,* *......,. ..,, • •• • • ,,co* leJ* QI* eJ** Jo* *,oo ** •Qe ** •*t •* *l
• Turn the control dial to proper cycle and pull dial out to start the washer. If
equipped with buttons, be sure they are fully depressed.
Won't Fill • Turn both faucets on fully.
• Straighten inlet hoses.
• Disconnect hoses and clean screens. Hose filter screens may be plugged.
• e•o ,* o* I* Jo.**. **. .. ... .. * .. ... ... **. *. *.. *. *.. **. **. ,**. *** *,* ... •
• Make sure the lid is completely closed.
• Turn the control dial to proper cycle and pull dial out to start the washer. If
equipped with buttons, be sure they are fully depressed.
• Close lid and pull dial out to start the washer. For your safety, washer will
Won't Agitate not agitate or spin unless the lid is closed.
• The washer is equipped with a lid switch failure detector. If the lid switch
should malfunction, the detector will stop operations for your safety. Call for
service.
• Pauses are normal. Wait and see if the washer will start again.
• Straighten drain hoses. Eliminate kinked hoses. If there is a drain restriction,
call for service.
• Close lid and pull dial out to start the washer. For your safety, washer will
Won't Spin not agitate or spin unless the lid is closed.
or Drain • The washer is equipped with a lid switch failure detector. If the lid switch
should malfunction, the detector will stop operations for your safety. Call for
service.
• If drain height is over five feet, a high-volume pump may be necessary. See
installation instructions or call 1-800-688-9900.
Load is wetter • The washer is designed to reduce spin speed if an unbalanced load is
than normal at the detected. This is normal.
end o1'the cyele • Redistribute the load in the tub and set the washer on SPIN.
Cont.
7