Filter
Top Products
Before You Call (continued)..................................
Check these )oints if your washer...
•Tum the control dial to proper cycle and pull dial out to start the washer. IJ
equipped with buttons, be sure they are fully depressed.
• Close lid and pull dial out to start the washer. For your safety, washer will no1
Stops agitate or spin unless lid is closed.
• This may be a pause or soak period in the cycle. Wait briefly and it may start
• The washer is equipped with a lid switch failure detector. If the lid switcl_
should malfunction, the detector will stop fill operations for your safety. Call
for service.
eoe eoeee ooeeooe el,e ell. • eeoee iooeeoeoeeeoeeeoooleloeeeltoee .e. eeee*eeeeeoeeeooeeee,oeeeo*ooo ..ee............ ee • eo*eeeo**ooeooee*
• Make sure hose connections are tight.
• Make sure end of drain hose is correctly inserted and secured to drain facility
Leaks Water • Avoid extended soaking - soak for 30 minutes or less.
• Avoid overloading.
oeloeooeeeeo,*oeleoeee*oeoo* ,e J, • oeeo*oleooe4eoooeie*teeee • e•oo*oeeoo*oe o*oeeo*o*eo*
• ....,...... .. • ......e.....e.,..e........ • •
• Be sure washer is leveled properly as outlined in installation manual.
• Weak floors can cause vibration and walking.
• Be sure rubber feet are installed on leveling legs.
Is Noisy • A clicking sound may be the LoadSensor TM agitator as it moves the load down
through the cleaning zone for maximum cleaning effectivness. This sound will
vary from load to load. This is normal.
• Operating sounds will vary depending on agitation speed.
• Turn both faucets on fully.
• If equipped with a temperature selector dial, be sure it is set directly on a tem-
perature setting and not between settings.
Fills with • Make sure temperature selection is correct.
the Wrong • Make sure hoses are connected to correct faucets and inlet connections. Be
Temperature sure water supply is regulated correctly. Flush water line before filling
Water washer.
• Check the water heater. It should be set to deliver a minimum 120°F (49°C)
hot water at the tap. Also check water heater capacity and recovery rate.
• Disconnect hoses and clean screens. Hose filter screens may be plugged.
• ....e......*..e....e....e.., .............. ... • ........... ..... .. • • • • • , .,•,,. • • ,
Cycle Selector
Dial Advances • Second Rinse is selected.
Through "OFF"
• .. • • ,.e .., ..,.e • • ,
Forfurther asSistancecontact Maytag Appliances Sales Company, Maytag CustomerAssistance:
U.S: I:800-688i9900 or Canada 1_800:688-2002
U.S. customersusing TTY for deaf, hearing impaired or speech impaired, call 1-800-688-2080.
8