Filter
Top Products
5
Drain System
Standpipe Drain System
The standpipe drain requires a minimum diameter standpipe of
50 mm (2"). The minimum carry-away capacity can be no less
than 64 L (17 gal.) per minute.
The top of the standpipe must be at least 990 mm (39") high
and no higher than 1.83 m (72") from the bottom of the washer.
Product Dimensions
N
Cold
Hot
A
B
C
E
D
F
G
I
K
L
M
H
A. 1.09 m (43")
B. 970 mm (38
1
⁄8")
C. 890 mm (35")
D. 38 mm (1
1
⁄2")
E. 705 mm (27
3
⁄4")
F. 650 mm (25
1
⁄2")
G. Water inlets
H. 180 mm (7")
I. Power supply cord
J. Drain hose connector
K. Label
L. 685 mm (27")
M. 133 mm (5
1
⁄4")
N. 25 mm (1")
O. Water level switch and shaft
P. 127 mm (5")
Electrical Requirements
■ A 220-240 volt, 50 Hz., AC only, 10-amp, fused electric
supply is required. A time-delay fuse or circuit breaker is
recommended. It is recommended that a separate circuit
serving only this appliance be provided.
■ This washer is equipped with a power supply cord having
an earthing plug. The plug should be accessible for
disconnection from the supply.
■ If the supply cord is damaged, it must be replaced by the
manufacturer, its service agent, or similarly qualified . . . . . . . .
persons in order to avoid a hazard.
Using the universal cord included with this washer:
This washer is equipped with a universal cord with
interchangeable mains plugs.
1. Select the appropriate mains plug assembly from those
supplied and attach it to the mains cord connector.
2. Snap the 2 halves of the cord lock together over the
connector to retain it in position.
W10135309B v07.qxd:YC70811_W10135283A-En Fr 4/28/10 4:01 PM Page 5