Filter
Top Products
• Use Max Extract Spin Speed option.
• Try using a high efficiency detergent to reduce sudsing.
• Load is too small.Very small loads (one or two items) may not spin out completely.
• Make sure door is firmly closed.
• Make sure hose connections are tight.
• Make sure end of drain hose is correctly inserted and secured to drain facility.
• Avoid overloading.
• Use high efficiency detergent to prevent over-sudsing.
• Check fuse or reset circuit breaker.
• Straighten drain hoses. Eliminate kinked hoses. If there is a drain restriction, call for service.
• Close the door and push the START/PAUSE touchpad. For your safety, washer will not tumble or spin
unless the door is closed.
• After pressing the START/PAUSE touchpad, it will take a few moments before the clothes washer
begins to spin.The door must lock before spin can be achieved.
• See “Tub is Completely Full of Suds” below.
• Plug cord into live electrical outlet.
• Check fuse or reset circuit breaker.
• Close door and push the START/PAUSE touchpad to start the clothes washer. For your safety, washer
will not tumble or spin unless door is closed.
• This may be a pause or soak period in the cycle. Wait briefly and it may start.
• Check screens on inlet hoses at the faucets for obstructions. Clean screens periodically.
• Run the clothes washer through another complete cycle using cold water.
• Reduce detergent amount for that specific load size, soil level and water hardness.
• Use high efficiency or low sudsing detergent specially formulated for front load washers.
• Turn both faucets on fully.
• Make sure temperature selection is correct.
• Make sure hoses are connected to correct faucets and inlet connections. Flush water line before
filling washer.
• Check the water heater. It should be set to deliver a minimum 120°F (49°C) hot water at the tap.
Also check water heater capacity and recovery rate.
• Disconnect hoses and clean screens. Hose filter screens may be plugged.
• When warm rinse is selected, only the final rinse will be warm. The first two
rinses will be cold.
• While the washer is filling for cold or warm wash temperatures, both hot and cold
water will go through the dispenser as the automatic temperature control feature
checks incoming water temperatures.This is normal and will only happen the first time the washer is
used.
18
EFORE YOU CALL
B
For problem laundry solutions (i.e. fabric damage, residue, tangling) and special laundry care procedures, see the
enclosed Laundering Tips booklet.
Fills with the
Wrong
Temperature
Water
Tub is Completely
Full of Suds
Stops
Won’t Spin
or Drain
Leaks Water
Load is Too Wet at
End of Cycle
CONTINUED
CHECK THESE POINTS IF YOUR MAYTAG NEPTUNE
®
WASHER...