Filter
Top Products
29
Over flow. Phone Service.
Temperature stop fault. Faulty temperature
stop, phone Service.
Thermistor fault. Faulty thermistor, phone Ser-
vice.
Water inlet fault. Fault in the supply of water,
ensure:
- that the water tap is open.
- that the strainer in the water inlet connection
is not clogged.
1. Turn off the water tap.
2. Disconnect the hose.
3. Clean the strainer in the water inlet of the
machine.
4. Re-connect the hose.
5. Open the water tap.
6. Run the programme again to check that the
fault is remedied.
Water outlet fault. Faulty pumping, check the
drain hose and the drain pump.
1. Straighten out any kinks in the drain hose.
2. Is there anything stuck in the drain hose
outlet? Clear the hose.
3. Is the drain pump blocked by foreign ob
jects? Clear the pump, see Chapter 12, Care
and cleaning.
4. Run the programme Drain.
Wash motor fault. Phone Service.
0000 flashes at the top right of the display. The
machine has failed to spin.
1. The machine incorporates an out-of-balance
detector, which reduces spin speed or prevents
spinning from starting if the load is very unba-
lanced. Turn the main switch,
off and turn
it on again. Open the door and redistribute the
washing.
2. After correcting, run the programme Spin.
If
flashes at the lower right corner of the
display it is an indication that you have attemp-
ted to start a programme with the door open.
Close the door and try again.
WRONG LANGUAGE ON THE DISPLAY
If the language on the display becomes altered
for any reason, it can be restored to the initial
language again.
The available languages are Dansk, Deutsch,
English, Espanol, Français, Italiano, Nederlands,
Norsk, Portugués, Suomi and Svenska.
Proceed as follows to change the language:
Turn the main switch,
off and turn it on
again. Press the
Enter
button five times, then
press the
P1
button five times. These ten ti-
mes must be completed within fifteen seconds.
Within three seconds after pressing
P1
the
last time, step to the desired language using the
buttons.