Filter
Top Products
6
nstallation
I
Laundry
Tub
Washer
approx.
2cm
Drain Hose
Installation place requirement
Positioning
Install the washer on a flat hard floor. Timber base and suspended type floors can cause
excessive vibration and noise.
Make sure that air circulation around the washer is not impeded by carpets,rug etc.
• Never try to correct any unevenness in the floor with pieces of wood, cardboard or similar
materials under the washer.
• If it is impossible to avoid positioning the washer next to a gas cooker or coal burning
stove,an insulating panel(85x60cm) covered with aluminum foil on the side facing the
cooker or stove,must be inserted between the two appliance.
• The washer must not be installed in rooms where the temperature can drop below 0°C.
• Please ensure that when the washer is installed, it is easily accessible for the service
technician in the event of a breakdown.
• With the washer installed adjust all four feet using the transit bolt spanner provided
ensuring the appliance is stable, and a clearance of approximately 20mm is left between
the top of the washer and the underside of the work-top.
Level floor :
Allowable slope under entire washer is 1˚
Power outlet :
Must be within 1.5 meters of either side of location of
washer. Do not overload the outlet with more than one
appliance.
Additional Clearance :
Allow 10cm of clearance at the rear of the machine and 2cm
at each side.
Do not place or store laundry products on top of washer at
any time.
Do not use pre wash stain remonal chemicals on or near the
machine as they can damage the machines cabinet and
control panel finish.