Filter
Top Products
13
7. TROUBLE SHOOTING
7-1.BEFORE SVC CHECKING
Be careful of electric shock or disconnecting the parts while trouble shooting.
Voltage of each terminal in 220-240V~ and DC while applying an electric current.
7-2.QC TEST MODE.
Pressing Rinse, and Spin button simultaneously.
Power supply ON with pressing upper two button.Then buzzer sound twice.
Press the Start/Pause button as follows.
Press the Start/Pause button more 4 times until stop spinning
7-3.HOW TO KNOW THE WATER LEVEL FREQUENCY
Press the
Rinse and Spin button simultaneously.
ex) 241 : Water level frequency = 241 10
-1
=24.1
7-4.HOW TO KNOW TO TEMPERATURE OF EACH THERMISTOR
AT OPERATING CONDITION.
■ Thermistor in tub : Press the [WATER TEMP] button.
■ Thermistor in dry duct : Press the [DRY] button.
■ Thermistor in condensing duct : Press the [SPIN] and [DRY] button simultaneously.
The digits means water level frequency(10
-1
)
Pressing number of
Start/Pause button
Checking Point Display Status
None All lamps turn on
1 time Clockwise spin(right) Drum rpm(About 40~52)
2 times Low speed Spin Drum rpm(About 70~90)
3 times High speed Spin Drum rpm(About 90~110)
4 times Inlet valve for pre-wash operation Water level frequency(25~65)
5 times Inlet valve for main-wash operation Water level frequency(25~65)
6 times Inlet valve for dry operation Water level frequency(25~65)
7 times Counterclockwise spin(left) Drum rpm(About 40~52)
8 times
Heater is in operation for 3 sec.
Water temperature
9 times Draining pump operation Water level frequency
10 times
Dry operation for 6 minutes Auto off operation after 6 minutes