Filter
Top Products
16
MAINTENANCE
2
3
1
The water inlet filter
• " " error message will blink on the control panel when water does not enter the dispenser.
• If your water is very hard or contains traces of lime deposit, the water inlet filter may become clogged.
We recommend cleaning it every few months.
Before cleaning the washer interior, unplug the electrical power cord to avoid electrical shock hazards.
When disposing of the appliance, cut off the power cable, destroy the plug, and disable the door lock to prevent
young children from being trapped inside.
1. Turn off the
water tap.
2. Unscrew
the water
inlet hose.
3. Clean the
filter using
a hard
bristle
brush.
4. Tighten
the inlet
hose.
1. Open the lower cover cap
with a tool such as coin.
Turn the drain plug to pull
out the hose.
2. Unplug the drain plug ,
allowing the water to flow out.
At this time use a vessel to
prevent water from flowing
onto the floor. When water does
not flow any more, turn the
pump filter open to the left.
3. Remove any foreign objects from
the pump filter . After cleaning,
turn the pump filter clockwise
and insert the drain plug to the
original place. Close the lower
cover cap.
The drain pump filter
•
The drain filter collects threads and small objects left in the laundry.
Check regularly that the filter is clean to ensure smooth running of your machine.
• Allow the water to cool down before cleaning the drain pump filter.
CAUTION
Drain, using the drain hose, before opening the pump filter to remove objects.
Be careful when draining if the water is hot.