LG Electronics DLE5911W Clothes Dryer User Manual


 
11
Safety Instructions
Installation Instructions
Operating Instruction
Troubleshooting Tips
Customer Service
MANUFACTURED (MOBILE) HOME INSTALLATION
Dryer exhaust duct MUST NOT terminate under the
mobile home.
For proper operation, it is important that the dryer has
an ample amount of outside Fresh air. The opening
for outside air must be at least 25 in
2
(163 cm
2
)
When exhausting the dryer to the outdoors, the dryer
can be installed with “1” inch clearance at the sides
and rear. Clearance of the duct from combustible
construction must be a minimum of 2 inches
(5.08 cm).
Venting materials are not supplied with the dryer
(obtain locally).
The dryer can be installed in a manufactured (mobile)
home by following these instructions:
1. IMPORTANT : Gas dryers MUST be permanently
attached to the floor at the time of installation.
2 Electrical Connections (Electric Dryer Only) must be a
4-wire connection.
3 Venting - Dryer MUST be exhausted to the outdoors.
The dryer can be exhausted to the outdoors through
the back, left, right or bottom panel. Gas dryers
cannot be exhausted out the right side because of the
burner housing.
The dryer exhaust duct must be secured to the mobile
home structure.
Exhaust ducts MUST NOT be connected with sheet
metal screws or fasteners which extend into the duct.
Exhaust duct must not be connected to any other duct,
vent or chimney.
IMPORTANT : Installation must conform to the
Manufactured Home Construction and Safety Standards,
Title 24 CFR, Part 32-80 or Standard CAN/CSA-Z240 MH.
WARNING
To reduce the risk of fire and combustion
gas accumulation, the dryer MUST BE
EXHAUSTED TO THE OUTDOORS. Refer to
Section on Dryer Exhaust Requirements.
WARNING
To reduce the risk of fire, the exhaust
duct and weather hood MUST be
fabricated of a material that will not
support combustion. Rigid or flexible
metal pipe is recommended for a clothes
dryer.