LG Electronics DLE5932W Clothes Dryer User Manual


 
9
Safety Instructions
Installation Instructions
Operating Instruction
Troubleshooting Tips
Customer Service
Step 4: (Electric Dryer Only) Connect
Electrical Plug
For further assistance refer to section on Electrical
Requirements.
IMPORTANT : Use only a new U.L. listed No. 10
(copper wire only) three conductor power supply
cord kit rated 240 Volts (minimum)30 Amperes
and labeled as suitable for use in a clothes dryer.
NOTE : For more detailed information on
connection three-wire or four-wire plugs, refer to
section on Electric Dryer Electrical Requirements.
NOTE : Four-wire cord is required for mobile
homes or where codes do not permit grounding
through neutral.
Step 5: Wipe Out Inside of Dryer
Before using dryer for the first time, use an all-purpose
cleaner, or a detergent and water solution, and a damp
cloth to remove shipping dust from inside the dryer
drum.
Step 6: Plug In the Dryer
Refer to section on Electrical Requirements, and
connect the dryer to an electrical power source.
Step 7: Check Installation
Heat Source Check
Electric Dryers
Close the loading door and start the dryer in a heat
setting (refer to the Operating Instructions supplied with
the dryer). After the dryer has operated for three minutes,
the exhaust air or exhaust pipe should be warm.
Gas Dryers
Close the loading door, start the dryer in a heat setting
(refer to the Operating Instructions supplied with the
dryer); the dryer will start, the igniter will glow red and
the main burner will ignite.
IMPORTANT : If all air is not purged out of the gas
line, the gas igniter may go off before gas it is ignited.
If this happens, after approximately two minutes the
igniter will again attempt gas ignition.