Filter
Top Products
PowerSupplyCord DirectWire
FireHazard
Usea newULapproved30amppower
supplycord.
Usea ULapprovedstrain relief.
Disconnectpowerbeforemakingelectrical
connections.
Connectneutralwire(whiteor centerwire)to
centerterminal(silver).
Groundwire(greenor barewire)mustbe
connectedto greengroundconnector.
Connectremaining2 supplywiresto remaining
2 terminals(gold).
Securelytightenallelectricalconnections.
Failureto do so canresultin death,fire,or
electricalshock.
FireHazard
Use10gaugesolid copperwire.
Usea ULapprovedstrain relief.
Disconnectpowerbeforemakingelectrical
connections.
Connectneutralwire(whiteor centerwire)to
centerterminal(silver).
Groundwire(greenor barewire)mustbe
connectedto greengroundconnector.
Connectremaining2 supplywiresto remaining
2 terminals(gold).
Securelytightenallelectricalconnections.
Failureto do so canresultin death,fire,or
electricalshock.
1. Disconnect power.
2. Remove the hold-down screw and terminal block cover.
2
3
n n ,,
1. Center silver-colored terminal-block screw
2. Hold-down screw
3. Terminal block cover
4. External ground connector
3.
Assemble a ¾ in. (1.9 cm) UL approved strain relief (UL
marking on strain relief) into the hole below the terminal block
opening. Tighten strain relief screws just enough to hold the
two clamp sections together. Put power supply cord through
the strain relief, The strain relief should have a tight fit with the
dryer cabinet and be in a horizontal position.
4. Now complete installation following instructions for your type
of electrical connection:
4-wire (recommended)
3-wire (if 4-wire is not available)
8