Filter
Top Products
:: l!) i:ii:i:i'i!i:: iii i
Properly leveling and locking the feet on your washer avoids
excessive noise and vibration,
1. Check that the four Iocknuts on the washer feet are tightened
against the washer cabinet using a 14 mm open-end wrench,
2. Place the washer in its final location and check the levelness
of the washer. The washer should not move front to back,
side to side, or diagonally when pushed on its top edges.
Make sure all four feet are stable and resting on the floor.
3.
If the washer is not level, move the washer out slightly before
tipping back, First prop the front with a wood block, loosen
the Iocknuts and adjust the feet as necessary; then prop the
back and adjust feet as necessary. Repeat steps 1-3 until the
washer is level.
IMPORTANT" All four feet must be tightened. If the Iocknuts are
not tight against the washer cabinet, the washer may vibrate.
111iii !]ii: 1:: i,iii:!iiii,::1::
1. Check the electrical requirements. Be sure that you have the
correct electrical supply and the recommended grounding
method. See "Electrical Requirements."
2. Check that all parts are now installed. If there is an extra part,
go back through the steps to see which step was skipped.
3. Check that you have all of your tools.
4. Dispose of/recycle all packaging materials.
5. Check that the water faucets are on,
6. Check for leaks around faucets and inlet hoses.
7.
8.
g.
ElectdcaB Shock Hazard
Plug into a grounded 3 prong outlet,
Do not remove ground prong,
Do not use an adapter,
Do not use an extension cord,
Falure to foiow these instructions can resumt in death,
fire, or e[ectricam shock,
Plug into a grounded 3 prong outlet.
Read "Washer Use."
To test and to clean your washer, measure 1/2the detergent
manufacturer's recommended amount of HE High Efficiency
detergent for a medium-size load. Pour the detergent into the
detergent dispenser. Select NORMAL/CASUAL, and then
select START. Allow the washer to complete one whole cycle.
Use only HE High Efficiency detergent.
11