Filter
Top Products
5
REVERSING DOOR SWING
Your dryer is designed so the door swing may be reversed at
any time without additional parts. Conversion is accomplished
by transferring hinges to the opposite side of the cabinet.
To change the direction of the door opening:
1. Open the dryer door. Remove the four hinge hole plugs
from the left side of the door opening. Place nearby for
future installation. NOTE: You may need a plastic knife to
help pull out the plugs. Be careful not to scratch the paint.
2. Remove the four screws that secure the door hinges to the
dryer front panel (see below). NOTE: Remove one screw
from each of the two hinges first. Hold the door firmly before
removing the last two screws.
3. Rotate the door 180° and reinstall the door hinges to the
dryer front panel with the four screws.
4. Install the four hinge hole plugs in the open screw holes on
the right side of the door opening.
UNPACKING
1. Using the four shipping carton corner posts (two on each
side), carefully lay the dryer on its left side and remove
foam shipping base.
To prevent damage, do not use the
control panel or coin meter housing as a means to
pick up or move the dryer.
NOTE: On under counter model clothes dryers, the top panel
may be removed for installation.
2. Return the dryer to an upright position.
PACKING
FOAM
SHIPPING
REMOVE 4 SCREWS
(ONE FROM EACH
HINGE FIRST)
ROUGH-IN DIMENSIONS
(68.6 cm)
SIDE VIEW
OPTIONAL
VENT KNOCKOUT
4 3/8"
(11.1 cm)
47 1/2"
(120.7 cm)
REAR VIEW
(68.3 cm)
(2.54 cm)
(110.7 cm)
(6.5 cm)
(9.5 cm)
3/8" (0.96 cm) DIA.
GAS PIPE
ELECTRIC CONNECTION
13 1/2"
(34.4 cm)
3 3/4"
(9.5 cm)
36"
(91.5 cm)
(20.4)
<>
4
3/8
(11.2)
17
(43.2)<>
v
^
8