Filter
Top Products
Typical Full Load Chart
Load Loading Load Loading
Type Suggestion Type Suggestion
Mixed 2 double or Heavy
Load 1 king size sheet Work
4 pillowcases Clothes
6 T-shirts
6 pair shorts
2 boy's shirts
2 blouses
6 handkerchiefs
2 pair work pants
3 work shirts
1 coverall
3 pair jeans
WASHER CARE
LUBRICATING
Every Kenmore Automatic Washer is thoroughly lubricated at the
time of assembly and should not require further lubrication under
normal operating conditions. In exceptional cases where
lubrication is required, the following guide is provided,
Component Lubricant Application
Instructions
Gearcase SAE60
Non-Detergent,
Non-Foaming
Motor Oil
Replace with 15 oz
(444 mL) of oil whenever
gearcase is repaired,
One pint (473.2 mL) cans
are available as Part
Number 350572.
Lower Turbine Oil Use 1/4oz (7.4 mL) of
Centerpost turbine oil (available in
Bearing pint cans), in the lower
centerpost bearing
before installing the
gearcase and
superstructure.
Rear Leveling Lubriplate Rub lightly on moving
Link 630-2 parts as required.
Mechanism
Agitator Shaft & Turbine Oil Upon repair or
Upper inspection, fill cavity
Centerpost above centerpost
Bearings bearings with turbine oil,
NOTES:
• Shut off hot and cold water outlets when washer is not in use.
• Drain machine to avoid damage ifwasher will be subjected to
freezing temperatures.
Be sure the open end of the drain hose does not fall or drop
down lower than the water level in the machine, Water will siphon
out of washer if this happens.
1. Unplug washer or disconnect power.
2. Coil power cord and tape to rear of washer.
3. Remove inlet hoses from faucets. Push them into washer. Do
not kink.
4. Remove wire form and push drain hose into washer. Do not
kink,
5. Tape lid closed.
6. Prop washer up about 4" (10,2 cm) on one or two corner
posts from shipping carton, remove spacers, and turn front
feet in flush with cabinet,
7. Push rear leveling legs up and tape securely,
8. Stuff a blanket between top of basket and washer lid except
in area of lid switch.
9. Washer is ready for shipping,
NOTE: When washer is reinstalled, use new hoses.
If you need an additional parts list, contact your local Sears store
or Sears Service Center. Make sure to furnish the complete
model number when ordering.
12