Filter
Top Products
17
Options
You can customize your wash by adding options to your cycle
selections. You can add or change an option after starting a cycle
anytime before the selected option begins. Not all Options are
available with all cycles. Current selections will glow green. If an
option is unavailable with a selected cycle, the light will not
illuminate.
■
See the
“
Laundry Guide
”
section for an overview of possible
options for each Wash Cycle selection.
■
You can select more than one option for a cycle. Some
options cannot be added to some cycles, for example, Stain
Treat cannot be added to the Express Wash cycle.
■
If an option is unavailable with a selected cycle, there will be
3 short tones, and the light for that option will not glow when
selected.
My Cycle
My Cycle allows you to store a customized wash cycle for future
use.
To Customize a Wash Cycle:
1. Select a cycle.
2.
Select the desired OPTIONS.
3.
Select the desired MODIFIERS.
4. To save the cycle press and hold MY CYCLE (approximately
3 seconds) until a beep sounds and the letters
“
SET
”
are
displayed on your machine.
5. Press START.
6. To reuse this cycle at another time, select MY CYCLE and
press START.
Prewash
Use this option for loads of heavily soiled items that need
pretreatment. This option adds 20-minutes prewash without drain
to the main wash cycle.
Add detergent to the Main Wash compartment of the Dispenser
Drawer.
NOTE: The Prewash option cannot be selected with the Soak,
Express, Handwash/Delicate Rinse/Spin cycles.
Normal Rinse
Consists of a two phase rinsing process that is effective for
everyday laundry.
2nd Rinse
A second rinse can be used to aid in the removal of detergent or
bleach residue from garments. This option provides an additional
rinse with the same water temperature as the Normal rinse. This
is the default rinse setting for the Whitest Whites cycle.
Extended Spin
Use this option to add an additional spin to any cycle to improve
drying times for some heavy fabrics or special-care items by
reducing excess water, which may save energy.
Button Sounds
Button sounds are used to notify you of what has been selected
or to let you know when something is not available. Button
sounds may be turned on or off by selecting BUTTON SOUNDS.
Delay Start
To begin the wash cycle later, select DELAY START until the
desired delay time (in hours) shows in the Estimated Time
Remaining display, and then select START. The countdown to the
wash cycle will show in the display window.
IMPORTANT: When delaying a cycle, use only powdered
detergents in the main wash compartment since liquid detergents
may seep out of the compartment during Delay, before the wash
cycle begins.
Cycle Signal
This signal is helpful when you are removing items from the
washer as soon as it stops. Select Loud, Soft or Off.