JVC LT-32A61BJ Washer/Dryer User Manual


 
42
Additional preparation
LT-32/26A61BU/SU / LCT1996-001A-U / English
Equipment which can output the
S-VIDEO signal (Y/C signal) such
as an S-VHS VCR
Connect the equipment to an EXT-2 terminal.
You can choose between an S-VIDEO signal
(Y/C signal) and a regular video signal
(composite signal). For details of how to
operate the equipment, see “S-IN (S-VIDEO
input)” on page 37.
T-V LINK compatible VCR
Be sure to connect the T-V LINK compatible
VCR to the EXT-2 terminal. If not, the T-V
LINK function will not work properly.
When connecting a T-V LINK compatible
VCR to the EXT-2 terminal, be sure to
connect the decoder to the VCR. If not,
the T-V LINK function may not work
properly.
When you connect the decoder to the
VCR, after you have stored TV channels
in the programme numbers (PR) list, set
the DECODER (EXT-2) function for the
programme number (PR) to ON to
unscramble a scrambled TV channel. For
details, see “DECODER (EXT-2)” on
page 36.
Connecting headphones
Connect the headphones with a stereo mini-
jack (3.5 mm diameter) to the headphone
socket at the TV rear panel.
No sound comes from the TV speakers
when the headphones are connected.
Video or sound signal output from
the EXT-2 terminal
You can change over the output of the video/
sound signal from the EXT-2 terminal. This
is useful when you want to dub the video/
sound from another device onto the VCR
connected to the EXT-2 terminal. For details
on how to do this, see “DUBBING” on
page 38.
The signals from EXT-4 and PC IN
terminal cannot be output from EXT-2.
TV output from the EXT-1 terminal
The video/sound signal of a TV channel you
are viewing is always output from the EXT-1
terminal.
Changing over a programme number (PR)
also changes over the TV output from the
EXT-1 terminal.
The video/sound signal from an EXT
terminal cannot be output.
Teletext programmes cannot be output.
Connecting to the computer
Connect the D-SUB cable with “DVI-I”-“D-
SUB” convert adapter from the computer’s
analogue RGB output terminal to the DVI
terminal on the back of the TV.
If you want to listen to the sound from the
computer, use an audio cable to connect the
VIDEO-3 AUDIO L/R sound input terminal
to the computer’s sound output terminal.
When the sound from the computer is mono,
connect to the VIDEO-3 AUDIO L terminal.
To watch images from a computer, start the
computer and press the G or p p buttons
to choose “PC”.
Refer to the computer’s manual for a
detailed explanation of the connections at
the computer side.
Ensure that the connectors are facing the
correct way when connecting.
After connecting the D-SUB cable with
“DVI-I”-“D-SUB” convert adapter,
tighten the two screws to fix the connector
in place.
Digital output with a DVI cable is not
supported.
LT-32&26A61BUSU_Eng.book Page 42 Tuesday, October 11, 2005 6:07 PM