Filter
Top Products
13
● The washing machine has stopped with water
in the tub, at the end of the “Soak” or of a
programme with the “Rinse hold” or “Quiet”
option: this is indicated by a flashing zero. The
Start/Pause light goes out but the “Door lock” pilot
light is still on. The door cannot be opened.
If your laundry is not removed during 10 minutes
after the programme has finished, all pilot lights and
the display switch off and the energy saving system
will be enabled. Only the green Start/Pause light
flashes to indicate that the appliance has to be
switched off.
● Delay start, a time value indicated in hours and
minutes and selected by pressing the delay start
button.
The delay time (20 hours max) is displayed for 3
seconds, then the duration of the selected
programme reappears.
After you have pressed the Start/Pause button, the
countdown is updated every hour, and, for the last
hour, every minute.
● An incorrect option selection has been made:
this is indicated by the message Err for about 2
seconds when an option incompatible with the
current programme is selected.
● An alarm code indicates a fault with the machine
(see the relevant chapter).
4 “Spin” button
Press this button repeatedly to change the spin speed if
you want your laundry to be spun at a speed different
from the one proposed by the washing machine.
Maximum speeds are:
• Cottons, linen: 1600 r.p.m.;
•“Automatic” programme: 1600 r.p.m. ;
• Synthetics and 14 Minute wash: 900 r.p.m.;
• Wool and Handwash: 1000 r.p.m.;
• Delicates and Silk: 700 r.p.m.
By pressing the Spin speed button you can also choose
No Spin option «
00
», Rinse Hold option
« » and Quiet option « ».
No spin «
00
» option eliminates all the spin phases and
increases the number of rinses for Cottons, Synthetics,
Delicates, Silk and Automatic.
Rinse hold position : when you choose
this option, the machine will not drain the water of the
last rinse, so as not to crease the laundry. The selected
option will be displayed.
Quiet position : when you choose this option,
the machine will not drain the water of the last rinse,
so as not to crease the laundry. The selected option
will be displayed.
As all spinning phases are cancelled, this washing cycle
is very quiet and it can be selected at night or in times
with a more economical power rate.
On cotton, synthetic, delicates, silk and Automatic
programmes the rinses will be performed with more
water.
If the Rinse Hold or Quiet option has been selected
the “Door lock” light is on, the “Start/Pause” button
light goes out and the display shows a flashing «
0».
The door cannot be opened because the water must
be drained.
To empty out water there are 2 options:
- Select
“
Drain” programme and press the
“Start/Pause” button: the water is emptied out
without spinning.
- Select “Spin” programme. Select the spin speed by
means of the relevant button and then press the
“Start/Pause” button. The water is emptied out
and the laundry is spun at the selected spin speed.
Attention!
Before selecting
“
Drain” programme or “Spin”
programme the selector dial must first be turned to
the «Off» position.
Quiet
Rinse hold
Quiet
Rinse hold
132972751.qxd 07/12/2007 11.38 Pagina 13