Filter
Top Products
12
1 Detergent dispenser drawer
2 Programme selector dial
The programme selector dial is divided into the
following sections:
• Cottons
• Synthetics
• Delicates / Silk
• Wool
/
Hand washing
• Special programmes from “Soak” to “14 Minute
wash”
• Reset/Off programme Off
The selector dial can be turned either clockwise or
anticlockwise.
“Economy” position corresponds to an ENERGY
SAVING programme.
Before setting the dial to any position ensure that the
machine is turned to the “Off” position.
IMPORTANT!
At the end of the programme the selector dial
must be turned to position “Off”, to switch the
machine off.
Attention!
If you turn the programme selector dial to another
programme when the machine is working, the red
Start/Pause pilot light will flash 3 times and the
message Err is displayed on the display to indicate a
wrong selection. The machine will not perform the
new selected programme.
30°
Silk
Drain
Rinse
Off
14 Minute wash
90°
Economy 60°
60°
30°
40°
60°
30°
Economy 40°
40°
Hand wash
Soak
Delicates 40°
Delicates 30°
Spin
Wool
Automatic
The control panel
12
3
4
5678 9 10
11
Delay start
Door lock
Start/Pause
Quick
Extra rinse
Options
Easy iron
Spin
Child lock
30°
Silk
Drain
Rinse
Off
14 Minute wash
90°
Economy 60°
60°
30°
40°
60°
30°
Economy 40°
40°
Hand wash
Soak
Delicates 40°
Delicates 30°
Spin
W
ool
Automatic
JLWM1604
3 Display
The following pieces of information are shown on the
display:
● Duration of washing programme in hours and
minutes, after you have selected a programme.
While the programme is running (after you have
pressed the Start/Pause button), the displayed time
value decreases by one unit every minute.
Attention!
When selecting the «proportional» programmes,
the display shows the washing duration of the
maximum recommended load. After the Start/Pause
has been pressed, on the display the «Wash time»
starts flashing to indicate that the appliance is
calculating the laundry amount and the real duration.
During this time, the washing duration shown
decreases.
When the calculating phase has finished, the «Wash
time» stops flashing and the washing time is adjusted
to the real load.
● The washing machine has completed the
programme: this is indicated by a flashing zero.
The “Door lock” pilot light and the Start/Pause
light go out and the door can be opened.
Start/Pause
132972751.qxd 07/12/2007 11.38 Pagina 12