Filter
Top Products
7
To keep vibration and noise to a minimum when the
dryer is in use, it should be placed on a firm, level surface.
Once in its permanent operating position, check that the
dryer is absolutely level with the aid of a spirit level. If it is
not, raise or lower the feet until it is.
The feet must never be removed.
Do not restrict the floor clearance through deep-
pile carpets, strips of wood or similar. This might
cause heat build-up which would interfere with the
operation of the appliance.
Important
The hot air emitted by the tumble dryer can reach
temperatures of up to 60°C. The appliance must be sited
in a well ventilated room but not be installed on floors
which are not resistant to high temperatures.
When operating the tumble dryer, the room temperature
must not be lower than +5°C and higher than +35°C, as it
may affect the performance of the appliance
.
Stacking kit (optional accessory)
It should be possible to stack your new dryer on top of a
front loading washing machine with cover’s depth
between 48 and 60 cm.
Read carefully the instructions supplied with the stacking
kit.
Please contact your local John Lewis branch for further
advice.
Door reversal
To make it easier to load or unload the laundry the door
can be reversed.
This operation must be carried out by qualified
personnel.
Please contact The telephone number given under
Repairs - After Sales Service (page 21).
P1148
Unpacking
Warning !
Slide out the polythene bag containing the
polystyrene block before using the appliance. Pull
off adhesive strips from inside machine on top of drum.
Keep all packaging away from children.
Should the appliance be moved, it must
be transported vertically.
Remove the rack
The drying rack offers the possibility of drying washable woollen
fabrics and sports shoes. The drying rack does not turn with the
tumble dryer drum. This enables the drying of woollen garments
or sports shoes. When wet, the wool must be moved as little as
possible because it tends to become matted. Sports shoes could
damage the drum due to their weight.
1. Lift the rack out of the polystyrene protection used for
transport and remove it from the tumble dryer drum.
2. Remove the pieces of polystyrene from the drum one
at a time.
3. Remove the elastic band from the rack and the rack
container.
Positioning
It is recommended that, for your convenience, the
machine is positioned close to your washing machine.
The tumble dryer must be installed in a clean place,
where dirt does not build up.
Air must be able to circulate freely all around the
appliance. It is important to ensure the air intake grills on
the back of the dryer are not obstructed with any
materials (e.g. paper, rags etc.). Obstructing the grills
could be dangerous or at least seriously impair the
efficiency of the tumble dryer.
P1106
125986600.qxp 2007-03-16 10:28 Page 7