Filter
Top Products
19
Adjusting the level of conductivity
Water contains, a variable quantity of limestone and
mineral salts of which quantities vary according to
geographical locations thus varying its conductivity values.
Relevant variations of the conductivity of the water
compared to those prefixed by the factory could slightly
influence the residual humidity of the laundry at the end
of the cycle.
Your dryer allows you to regulate the sensitivity of the
drying sensor based on conductivity values of the water
by using the following procedure
.
To establish the hardness of your water to correspond
with the table opposite please contact your local water
authority.
Procedure:
Turn the programme selector dial to switch on the
appliance
In selection mode press simultaneously the buttons
Quick and Start/Pause until «C0» appears on the digits.
Adjusting the level of conductivity:
Press the button Start /Pause sequentially: the level of
conductivity is indicated by the lighting of the horizontal
hyphens.
Memorising the new setting:
Dry time
Delay start
Start / pause
Filter
Full tank
Condenser
Alarm
Intensive
Quick
Half power
Time
Child lock
1.25
Dry time
Delay start
Start / pause
Filter
Full tank
Condenser
Alarm
Intensive
Quick
Half power
Tim
e
C
hild lock
Extra dry
Store dry
Cupboard dry
Damp dry
Iron dry
Extra dry
Iron dry
Cupboard dry
Off
Refresh
Rack dry
Easy iron
Extra delicate
Wool
30 minutes
Simultaneously press down the buttons Quick and
Start/Pause until the previous drying cycle time appears
again on the display and the buzzer sounds.
Display
Conductivity
degree
Approximative
value (µS/cm)
CC 00
Low < 300
CC 00
Medium 300 - 600
CC 00
High > 600
125986600.qxp 2007-03-16 10:28 Page 19