Filter
Top Products
Drying cycle
to short
Small laundry volume./Too dry laundry
for selected programme.
Select time programme or higher drying
level (e.g. Extra dry ).
Drying cycle
to long
5)
Fluff filters clogged. Clean fluff filters.
To high loading volume. Respect max. loading volume.
Laundry insufficiently spun. Spun adequately the laundry.
Particularly high room temperature - no
machine fault.
Lower the room temperature if possible.
1) In case of error message on the LCD (e.g. E51 ): Switch the dryer off and on. Set programme. Press the Start/
Pause button. Does not work? - inform local service and quote the error code.
2) follow program recommendation - see Programme chart chapter
3) see Maintenance and cleaning chapter
4) see Machine settings chapter
5) Note: After around 5 hours the drying cycle ends automatically (see Drying cycle complete section).
Replacing the drum light
Only use a special bulb which is designed
specially for dryers. The special bulb can be
obtained from your local Service Force
Centre.
Important! When the appliance is
switched on, the interior lighting switches
itself off after 4 minutes when the door is
open.
Warning! Do not use standard
bulbs! These develop too much heat
and may damage the machine!
Warning! Before replacing the bulb,
disconnect the mains plug; with a
permanent connection: fully unscrew
or deactivate the fuse.
1. Unscrew the cover above the bulb (this
can be found directly behind the loading
aperture, at the top; refer to
“Description of machine” section.)
2. Replace the defective bulb.
3. Screw cover back down.
Check the correct positioning of o-ring
gasket before screwing back the door light
cover. Do not operate the dryer when
missing o-ring gasket on door light cover.
Warning! For safety reasons, the
cover must be screwed down tightly.
If this is not done, the dryer must not
be operated.
Machine settings
Alarm permanent on/off
The alarm is by default always off. To set
permanent alarm on (off):
1. Turn the programme selector to any
programme.
22