Filter
Top Products
1. Drapethepowercordovertheconsole.
2. Movethewashertoitsfinallocationandremoveany
cardboardusedtomovewasher•
3. Placethedrainhoseinthelaundrytuborstandpipeas
shown•SeeillustrationsAandB.
i
C
4. If the washer faucets and the drain standpipe are recessed,
put the hooked end of the drain hose in the standpipe as
shown• See illustration C.
NOTE:
• Do not force excess drain hose back into the rear of the
washer•
• To prevent siphoning, do not seal the drain hose into the
standpipe.
3=
If the washer is not level, prop up the front of the washer with
the wood block and adjust the feet up or down as necessary.
If the washer is against a wall, move the washer out slightly
before tipping back. Repeat this step until washer is level.
1. Check the electrical requirements. Be sure that you have the
correct electrical supply and the recommended grounding
method. See "Electrical Requirements•"
2. Check that all parts are now installed• If there is an extra part,
go back through the steps to see which step was skipped.
3. Dispose of or recycle all packaging materials. Keep the
shipping bolts, spacers, and transport bars for use if the
washer should be transported.
4. Check that all the water faucets are completely on.
5. Check for leaks around faucets and inlet hoses.
Properly leveling your washer prevents excessive noise and
vibration•
Excessive Weight Hazard
Use two or more people to move and install washer.
Failure to do so can result in back or other injury.
1=
2.
Move washer to its final location.
Check that the washer is level•
• Check side to side and back to front by lining up the level
as shown in the following illustration.
o
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord,
Failure to follow these instructions can result in death,
fire, or electrical shock.
6. Plug into a grounded 3 prong outlet.
7. Read "Washer Use."
8. To test and to clean your washer, measure and add 1/2the
normal recommended amount of High Efficiency (HE)
detergent to the washer. Close the door. Select any cycle,
and then press START• Allow it to complete one whole cycle.