Filter
Top Products
7
GB
Setting the temperature
Turn the TEMPERATURE knob to set the wash
temperature (see Programme table on page 6).
The temperature can be lowered, or even set to cold
wash (
).
Setting the spin speed
Turn the SPIN SPEED knob to set the spin speed for
the programme selected.
The maximum spin speeds for each programme are as
follows:
Programmes Maximum spin speed
Cotton 1400 r.p.m.
Synthetics 800 r.p.m.
Wool 600 r.p.m.
Silk no
The spin speed can be lowered, or the spin cycle can
be excluded altogether by selecting the symbol
.
The washing machine will automatically prevent you
from selecting a spin speed higher than the maximum
speed for each programme.
Personalisations
Option Effect
Comments
Enabled with
programmes
Delay Timer
Delays the start of the
wash by up to 12
hours.
Press the button repeatedly until the LED corresponding
to the delay flashes.
The fifth time the button is pressed, the option will be
disabled.
N.B. Once you have pressed the Start/Reset button, the
delay can only be decreased if you wish to modify it.
All
Mini Load
For washing a smaller
load.
In addition to reducing actual washing time, this option will
reduce water and energy consumption by up to 50%.
Note: You can reduce the amount of detergent you use
with this wash.
1, 2, 3, 4, 5
Rinse cycle
Easy Iron
This option reduces
the amount of
creasing on fabrics,
making them easier
to iron.
When this option is set, programmes 4, 5, 6, 7 and Rinse
cycle will end with the laundry left to soak (Anti-crease)
and the Rinse cycle phase LED will flash.
- to conclude the cycle, press the START/RESET button.
- to run the draining cycle alone, set the knob to the
relative symbol and press the START/RESET button.
3, 4, 5, 6, 7,
8, 9, 10,
Rinse cycle
Extra Rinse
Increases the
efficiency of the rinse.
Recommended when the appliance has a full load or with
large quantities of detergent.
1, 2, 3, 4, 5,
8, 9, 10, 12, 13
Rinse cycle
Options
To enable an option:
1. press the button corresponding to the desired
option, according to the table below.
2. the option is enabled when the corresponding
button is illuminated.
Note: The rapid flashing of the button indicates that
the corresponding option cannot be selected for the
programme set.