Filter
Top Products
9
GB
Personalisations
Setting the spin cycle
If, when the appliance is switched on, the KNOB is positioned on
a programme with a spin cycle, a fixed
appears. Press button
and the maximum spin speed allowed for the programme set
will be displayed, and the
icon flashes. Press it again and the
values lower until they reach OFF, which indicates that the spin
cycle has been excluded (press it again to go back to the
maximum value); stop on the desired speed, after approximately
2 seconds the setting is accepted: the symbol
remains fixed.
The spin cycle setting is enabled with all the programmes except
for 5 and the Draining cycle.
Setting the delay timer
Press the button and you will see the word OFF on the
display, while the relative symbol flashes.
Press the button again and "1h" appears, that is, a delay of one
hour (this can reach up to 24h); stop on the "desired" delay; after
approximately 2 seconds the setting is accepted, following which,
the time for the set programme appears on the display and the
symbol
remains on.
If you now press the START/RESET button, the set "delay" appears; this decreases every hour until the start of
the cycle. In this phase, the "delay" can only be modified by decreasing it. The Delay Timer regulation is enabled
with all programmes.
Setting the temperature
If, when the appliance is switched on, the KNOB is positioned on a programme for which the temperature needs
to be regulated, a fixed
appears. Press button and the maximum temperature allowed for the programme set
will be displayed and the
icon flashes. Press it again and the temperature lowers until it reaches OFF, which
indicates a cold wash cycle (press it again to go back to the maximum value); stop on the desired value, after
approximately 2 seconds the setting is accepted: the symbol
remains fixed.
The temperature adjustment is enabled with all wash programmes.
Setting the drying cycle
If, when the appliance is switched on, the KNOB is set to a programme requiring a drying setting, press button
and the display will indicate the word OFF, while icon flashes.
Press it again and the Three times (40'-1:00-3:00) and the Three levels of drying available will be displayed in
sequence; stop at the desired type of drying; the setting will be accepted after approximately 2 seconds, then
the time for the programme set (including the drying time) will be indicated on the display and the symbol
will
remain on.
The drying cycle setting cannot be made with programmes 4-5-8-9-11-12-
.
N.B.: if the KNOB is set to one of the programmes (6-7) dedicated to drying only, icon
lights up
permanently, press button
and the drying level " " will indicated while icon flashes; then to select
the desired drying type, proceed as described above.
FUNCTION buttons