Filter
Top Products
H I
A
B
G
C
E
FD
1
2
3
Anti-crease
This button allows you to
interrupt a programme (on
symbol
) keeping the washing
soaking in water before the spin
cycle. It is a very useful button
in particular because it can be
used for delicates and
synthetics. It is only to be used
with wash programmes for
synthetic fabrics, silk and
curtains when it is impossible for
you to take the washing out
immediately. Before opening the
washing machine door, finish the
wash cycle as follows:
Silk and curtains:
press button D
and the machine will drain the
water.
Synthetic fabrics:
press button D
if you want a spin cycle, or turn
knob A to symbol
if you want
the water to be drained.
N.B.:
With Daily wash, this function
is not performed.
Slow spin
Use this button to reduce the
spinning speed from 1000 to
500 rpm for the cotton and linen
programmes and from 850 to
500 rpm for the synthetic
fabrics programmes.
Extra Economy
Reduces water consumption
during the rinse cycles. We
recommend that you use this
function only with small laundry
loads, dosing the detergent
proportionally.
Here I’m in command
Understanding the control panel
Making the right choice is important. And it’s easy.
Programme selector knob
Use this knob to select the wash
programme.
Turn this knob clockwise only.
To select a programme, you
should turn the knob so that the
symbol/number of the desired
programme is in line with the
pointer on the knob.
Now press on/off button G
(position I), pilot lamp H will start
flashing.
After 5", the setting will be
accepted, pilot lamp H will stop
flashing (staying lit) and the wash
cycle will begin.
Should you wish to interrupt the
programme in progress or set a
new one, select one of the
symbols
(Stop/Reset) and wait
5" : when the cancellation has
been accepted, pilot lamp H
flashes, and you can then turn the
appliance off.
After the wash cycle has been set
and accepted by the washing
machine, turning the knob will
have no effect (except for when
it is on position
Stop/Reset).
Drying cycle knob
Use this knob to select the
desired drying cycle. Two
options are available:
A - Based on time:
From 40 minutes to 150.
B - Based on the damp level of
the dry clothes:
Iron
:use this slightly damp
setting for clothes that you
intend to iron to reduce effort
and save energy in the drying
cycle.
Wardrobe
: use this setting
when you want dry clothes that
can be stored after hanging for
a short while.
Extra dry
: use this setting
when you want very dry clothes.
A cooling stage is foreseen at
the end of the drying cycle.
Detergent dispenser
It is divided into three
compartments:
1.Detergent for pre-wash;
2.Detergent for the main cycle
wash;
3. Fabric conditioner.
The detergent dispenser is here.
3
Instructions for installation and use
On-off
When button G is pressed, the
washer-dryer is switched on,
when it is not the machine is
switched off.
Turning the appliance off
does not cancel the selected
programme.
On-off lamp / door locked
Lamp H flashes slowly when the
appliance is switched on and
awaiting instructions and at the
end of a cycle, indicating that the
door can be opened. It flashes
quickly when the door should
not be opened. A steady light
means the appliance has
accepted the selected
programme.
Drying cycle lamp
When this lamp is on, it means
that knob B has been set on a
drying cycle and at the end of the
wash cycle, the appliance will run
the selected tumble drying cycle.