Filter
Top Products
5
Dryer Description
GB
Important
Information
Installation Description
The Display
Start and
Programmes Laundry
Warnings and
Suggestions
Troubleshooting Ser
vice
Maintenance
and Care
Control panel
PROGRAMME
Selection Buttons
Display Unit
START/PAUSE
Button & Light
CHILD LOCK
Button
ON/OFF
Button
OPTION
Buttons & Lights
To open the door The features
Water container
Air intake
grille
Rating plate
Filter
Model &
Serial
numbers
Condenser cover handle
(Pull to open)
Condenser cover
Press and release the front
panel in position shown
Condenser Unit
(cover open)
The ON/OFF button/light : If the dryer is running
and this button is pressed, the dryer is turned off.
Press again, the dryer restarts.
The PROGRAMME selection buttons set the programme:
press the button corresponding to the programme you
want to select (see Start and Programmes).
The OPTION buttons/indicators: these buttons select
available options for your selected programme (see
The Controls). The indicators on the display unit next
to the buttons light to show that the option has been
selected.
The START/PAUSE button/light starts a selected
programme. When you press this button there will be
one beep and the display will show PAUSED .
When a programme is running, holding this button in
pauses the programme and stops the dryer.
The light is green when the programme is running,
flashing amber if the programme has been paused or
flashing green if on standby waiting to start a programme
(see Start and Programmes).
The Display Unit gives warnings and information
about the programme (see next page).
The CHILD LOCK button/icon : Press and hold this
button after selecting your programme and any options,
this prevents the programme settings from being
changed, the display will briefly show LOCKED .
When the icon is lit, the other buttons are disabled.
Hold the button to cancel and the icon will go out, the
display will briefly show UNLOCKED .
Note: This tumble dryer, in compliance with new energy
saving regulations, is fitted with an automatic standby
system which is enabled after about 30 minutes if no
activity is detected. Press the ON-OFF button briefly
and wait for the machine to start up again.