Filter
Top Products
Setting Up
The machine should be levelled properly on the
floor. However, it can be installed on any suitable
platform or trolley, as desired.
Install machine in a room with adequate
ventilation. Avoid a room with no windows. The
back of the machine should be at least 4 inches
(100 mm) away from the wall.
1. Do not place the machine on slanting, uneven,
unstable surface.
2. Level the machine by using the adjustable screws provided at the
bottom for levelling.
3. Loosen securing nut. Adjust the screw to change level. Tighten
securing nut to ensure that screw is locked into place.
4. Make sure that the machine rests on all four feet on a level
surface, at all times, to avoid vibrations during operation
5. Machine should be leveled again in case it is moved to a new site.
6. Machine is provided with ventilating openings on the base. Hence it
is always recommended to put the machine on the floor after
removing the carpet.
7. In countries where there are areas which may be subjected to
infestation by cockroaches or other insects etc, pay attention to
keep the appliance & surrounding in clean condition at at all times
any damage which be caused by cockroaches etc will not be
covered by the appliance guratantee.
6. Remove transit bolts.
7. Insert plastic caps provided into holes vacated and press till they
click into place.
8. Keep transit bolts carefully. They will be required in case you need to
shift the machine again.
9. For shifting and re-installation at a new site, please get in touch with
our service personnel.
10. Keep packaging material carefully. It comes handy while shifting
residence.
11. PLEASE DO NOT OPERATE THE MACHINE TILL TRANSIT BOLTS
HAVE BEEN REMOVED.
9
rEnsure that the machine is properly balanced on four adjustable
feet.
rEnsure that the machine is connected to 3 pin socket with good
earth and 16 Amp MCB or other automatic short circuit
protection devices.
qThe machine is tested with water during assembly for performance
checking. Condensed droplets of water may remain
inside the drum. It is advisable to run the machine without wash
load in cotton 60 program with detergent for the first time
after installation.
rServicing should be handled by the Company’s authorized
personnel only.
rCheck label on garments for determining conditions under which
fabrics are to be washed.
rUse detergent recommended for washing machine.
rEnsure that the electrical line on which the machine is used can
take the required load.
rCheck the inside of drum before loading the clothes.
rProtect the machine from direct sunlight and do not splash water on
it. Clean with a dame cloth.
rKeep your machine dry to avoid corrosion/rusting. Take special care
to wipe the machine after cleaning the Coin trap.
rThe machine should ideally be installed on the floor. It can be
installed on any suitable platform or trolley, if desired by the
customer.
rClean the shell lower and detergent tray periodically by taking out
the detergent tray.
rDo not pull the cord to disconnect the plug. Hold the plug itself/do
not insert or remove the plug with damp hand.
rDo not drag the washing machine to its position. Always lift the or
move the machine keeping the wheel’s direction in mind.
rDo not move the washing machine if it contains the wash load or
when in operation.
rDo not install the machine in a damp area or bathroom, with
exposure to direct shower*.
rDo not spill water over the machine*. In case of spillage, wipe dry.
SAFETY PRECAUTIONS
36