Hotpoint WMD 942 P/G/A/K Washer User Manual


 
14
GB
The machine is noisy.
The machine wont spin properly.
The machine leaks from the di-
spenser.
The machine leaks (other than
dispenser).
The indicator lights on the console
are flashing rapidly.
The machine smells.
The machine door cannot be
opened.
Door Seal damaged at the bottom.
The water level is too low when
the machine is washing.
There is too much foam.
After completing the programme,
or before starting a programme,
the machine has turned itself off
(no lights).
General.
•Therewillalwaysbesomemotor,pumpanddrumnoiseduringspin.
•OutofBalancedetectedwhenattemptingtogointoaspincycle-Ifthis
happens the machine will continue to try to repeat the distribution of the load
required before the machine will go into higher spin speeds - This will increase
the programme time accordingly. This is a safety feature to prevent damage.
Out of Balance can be caused by washing a single heavy item (eg duvet, quilt,
etc). - Try the programme again using a different load.
•Thedispenserdrawerisblockedwithdetergentandrequirescleaning.
•Thewaterpressureistoohighandrequiresturningdown-turndownthetap
on the water supply pipe slightly and try again.
•Themachineistiltingforwards-Itmustbelevelwheninitsfinalposition.
•Thefillhoseisloose,checkboththecabinetandtapends.
•Thefillhoseistightbutstillleaks,ifsoreplacetherubberwashers,orthefill
hose is missing the rubber washer.
•Thedrainhoseisnotfixedinproperly.
•Switchoffthemachineandunplugit,waitforapproximately1minuteandthen
switch it back on again If the problem persists contact the Technical Assistance
Service.
•Themachinerequiresaservicewash.Runa90degreewashcyclewithdeter-
gent and no laundry.
•Thedoorwillnotopenuntilthedoorlockindicatorlightgoesoutshortlyafter
the program has finished.
•Thedoorsealhasdrainageholesatthebottom-Thisisnormal.
•Thewaterleveliscorrectifitcanbeseenatthebottomofthedoor.
•Thedetergentisnotsuitableformachinewashing(itshoulddisplaythetext
‘for washing machines’ or ‘hand and machine wash’ or the like).
•Toomuchdetergentwasused-lessdetergentisrequiredinsoftwater.
•Tocomplywithnewenergysavingregulationsthemachineisfittedwithan
automatic standby system. Press ‘ON/OFF’ button for 3 seconds to activate
the machine, it can then either be switched off or a new programme selected.
•Yourwashingmachinecontainssensorsthatmonitorprogressduringthewash
cycle (eg: Water Levels, Temperatures, Out of Balance loads, Wash time/pro-
gress).
Normally, if your machine successfully completes the cycle, there is unlikely to
be anything wrong!
Remember, you will be charged for a service call for problems caused by incorrect installation, as listed
above.
Not emptying contents from pockets may cause pump or drain blockages, or may damage the machine.
Do not wash items which do not have a wash label, or wash items that are not intended as machine
washable.