Hotpoint WM53 Washer User Manual


 
WARNINGS
Before using appliance,
remove transit bracket,
clamp and screws.
Retain parts for future
transportation.
Do not remove
concrete weight.
Replace work top lid and 3
screws.
Remove 2 screws and transit
bracket, retain.
Remove 1 screw and clamp,
retain.
From rear of appliance, grip
sides of work top lid, lift, slide
and pull towards you.
Slide and push work top lid into
position.
Remove 3 screws from back of
work top lid, retain.
Fig 1
1
2
3
4
5
7
Locate front edge into console.
6
Remember you may be
charged for a service call if a
problem with your
appliance is caused by
incorrect installation or
misuse.
2. Remove Transit Bracket...
Your appliance is fitted with an internal bracket (Fig 1) which prevents damage to the
appliance during transit. Remove parts (Fig 2) following the instructions below.
Note: It is normal for the door seal to look creased, it will not affect its use.
Transit Bracket
5
After removing the
packaging from the
machine, ensure that
the polystyrene
pyramid (shown below)
has come away from the
underside of the
machine, with the
polystyrene base.
If it has not come away,
remove it by tilting the
machine backwards until
the pyramid can be seen
and then remove.
Fig 2