Filter
Top Products
Using your Machine
STEP 5
On-Off / Selecting a programme...
To stop or change a programme...
Progress indicator lights...
Programme listing
Door Locked indicator light Progress indicator lights
‘Start/Cancel’
button
Programme selector dial
Variable Spin Speed button
Variable Temperature button
Option buttons
‘On/Off’button
Digital Display
The machine is switched on by pressing the ‘On/Off’button for 2 seconds. All the indicator lights will light up for a few seconds and
the ‘Door Locked’indicator light will flash once.
Turn the programme selector dial to the desired programme. Load the laundry and detergent. Select the options you require.
Press the ‘Start/Cancel’button for 2 seconds to start the programme.
Press the ‘Start/Cancel’button for 2 seconds.
Select ‘Pump Out’on the programme selector dial.
When the machine has finished emptying,turn the programme selector dial to the new programme (you may need to add
detergent). Press the ‘Start/Cancel’ button to start the programme.
●
If you cancel a hot wash programme, take care when removing the laundry, it might still be very hot.
These will light up when you choose a programme,to indicate the
progress of the selected programme. When started, the first light in
the cycle will stay lit and as the programme
progresses,successive lights will come on until the
programme finishes.
During a wash programme the display will show the time remaining
to the end of the programme.
Door Locked indicator light...
●
The ‘Door Locked’indicator light will come on two seconds after
you press the ‘Start/Cancel’button and will stay lit throughout the
programme. A short time after the programme has finished the
indicator light will go out and you can then open the door.
●
Selected programmes will not start if the door is not closed
properly, the ‘Door Locked’indicator light will flash to show this.
The display will also show the word ‘door’.
Push the door shut until you hear the catch click.
The machine will show on the display if there is a problem:
H20 A problem with the water supply.
Check that the taps are turned on and working.
door Please close the machine door properly.
F000 Indicates a machine fault.
Please note the number shown and refer to STEP8
WARNINGS:
● In the unlikely
event of something
not working,see
‘Troubleshooting’
STEP 8.