Filter
Top Products
6
Start and Programmes
GB
1. Select HIGH HEAT by pressing
the HEAT button.
2. Position the PROGRAMMES knob
on .
3. Press the START button , the
ACTIVE light will turn on.
1. Select HIGH HEAT by pressing
the HEAT button.
2. Position the PROGRAMMES knob
on .
3. Press the START button, the
ACTIVE light will turn on.
Programmes table (VTD20 only)
Programme
What it does...
How to set it...
Note:
Automatic
Drying
(average loads)
Dries completely:
your clothes are ready to be
worn. For average loads (from
1 to 3kg) of Cotton, polycotton
or synthetics.
! If you select LOW HEAT, this
programme will not dry your
clothes. For Acrylic fibres or
small loads select Timed
Drying.
This programme can also be
used for large loads if you
require a slightly drier result.
1. Select HIGH HEAT by pressing
the HEAT button.
2. Position the PROGRAMMES knob
on .
3. Press the START button, the
ACTIVE light will turn on.
Automatic
Drying
(large loads)
Dries completely:
your clothes are ready to be
worn. For large loads (from 3
to 6kg) of Cotton.
! If you select LOW HEAT, this
programme will not dry your
clothes. For Acrylic fibres or
small loads select Timed
Drying.
This programme can also be
used for average loads if you
prefer a damper result.
Timed Drying
up to 120 minutes
Dries wet clothes that will be
ironed, Acrylic fibres, or small
loads (less than 1kg).
Consult suggested drying
times (see Laundry).
Always allow the dryer to
complete this phase.
This is the programmes final phase.
Approximately 10 minutes before
the finish, the knob advances
automatically to the Cool Tumble
Phase. After this, the Buzzer will
sound (if selected) and the clothing
is ready to be taken out.
Heating elements turn
themselves off and clothing
is cooled down.
1. Select required heat setting HIGH
HEAT or LOW HEAT by pressing
the HEAT button.
2. Position the PROGRAMMES knob
on the desired time.
3. Press the START button, the
ACTIVE light will turn on.
Easy Iron
Cool Tumble
Phase
Brief programme
(approximately 10 minutes)
that softens fibres of clothing
that is ready for ironing.
!
This is not a drying
programme (see below).
Easy Iron Programme
‘Easy Iron’ is a short 10 minute programme (8 minutes of heat followed by a 2 minute cool tumble period) which
fluffs the fibres of clothing that have been left in the same position/location for an extended period of time. The
cycle relaxes the fibres and makes them easier to iron and fold.
! ‘Easy Iron’ is not a drying programme and should not be used for wet articles of clothing.
For best results:
1. Do not load more than the maximum capacity.
These numbers refer to the dry weight:
Fabric Maximum load
Cotton and Cotton mixtures 2.5kg
Synthetics 2kg
Denim 2kg
2. Unload the dryer immediately after the end of the programme, hang, fold or iron the articles and put
them away in the closet. Should this not be possible repeat the programme.
The ‘Easy Iron’ effect varies from one fabric to the next. It works well on traditional fabrics like Cotton or Cotton
mix, and less well on acrylic fibres and on materials such as Tencel®.