Filter
Top Products
13
Description Contents
Programmes
and Option
Modifiers
Control Panel
Features
Installation
Detergents
and Laundry
Care and
Maintenance
Precautions
and Advice
Something
Wrong? -
Troubleshooting
Service
GB
Automatic features
Unbalanced load detection:
The machine has an inbuilt feature to prevent it from spinning too fast with an unbalanced load. When an
unbalanced load is detected, the machine will attempt to redistribute the load in order to balance it evenly to
achieve full spin speed.
If this is not possible and an unbalanced load remains the spin speed will be reduced, depending on the amount
of unbalance detected. This is to prevent the machine from damaging itself or its surroundings and to prevent
excessive noise from the machine.
! If the spin result is unsatisfactory following a reduced spin speed attempt to rectify the unbalanced load, then
on completion of the programme the load can be redistributed evenly in the drum by hand. Select a spin cycle.
NNoottee::
Do not attempt to spin heavy or absorbent single items as the machine cannot distribute these evenly.
If you need to wash a single item you will need to add some other items as ballast to allow the machine to distribute
the load evenly throughout the drum.
No water detection:
The machine will automatically detect if it cannot take in water and will notify you by flashing the ‘tap’ icon
and showing ‘H20’ on the LCD display.
If this occurs please check the appliance is plumbed in correctly (see Installation ‘Water connection’).
Energy saving and water levels
Modern machines are designed to be as environmentally friendly as possible.
To achieve this water levels are kept to a minimum to ensure they are economic and use the lowest energy
possible. Unlike older appliances you will not see high water levels in the drum during washing.
! We recommend always washing as close to a full load as possible (see Programmes Table for the maximum
load size of your selected programme).
Option Modifiers and
Special Features
Option modifiers continued...
●
Stored Programme:
Use this option to store your favourite programme. Only one programme can be stored.
- To store a programme:
Load your machine and add detergent to the dispenser drawer. Select the programme and any options
required. Press the START/CANCEL button and the programme will start. Then press the ‘Stored’
option button twice and that programme will be stored for future use. ‘Saving Favourite’ will illuminate
on the LCD display for 2 seconds after the programme settings have been stored.
- To retrieve and use a stored programme:
Load your machine and add detergent to the dispenser drawer. Press the ‘Stored’ option button, your
favourite programme settings will appear on the LCD display. Press the START/CANCEL button to start
the programme.
- To change a stored programme:
Load your machine and add detergent to the dispenser drawer. Press the ‘Stored’ option button, your
favourite programme settings appear on the LCD display. Select the programme and option selections
for you new requirements, then press the START/CANCEL button to start the programme. Press the
‘Stored’ option button again and the new settings will replace the old. ‘Saving Favourite’ will illuminate
on the LCD display for 2 seconds after the programme settings have been stored.
●
Child Lock:
Select this option to disable all buttons so no programme and option selections can be altered.
Press the Child Lock option button and the option light will illuminate on the LCD display above the button.
Once Child Lock is selected it remains activated even when the machine is switched off. If power is interrupted
at any time pressing any button will reactivate the Child Lock feature. If Child Lock is activated and any
control buttons are pressed the option light will flash: no alterations to the settings will be allowed.
- Press and hold the Child Lock option button for 2 seconds to cancel, the option light will go out.