Filter
Top Products
6
GB
Instructions for the fitter
Mounting the wooden panel onto the door
and inserting the machine into cabinets:
In the case where the machine must be
shipped for final installation after the
wooden panel has been mounted, we sug-
gest leaving it in its original packaging. The
packaging was designed to make it pos-
sible to mount the wooden panel onto the
machine without removing it completely
(see figures below).
The wooden panel that covers the face
of the machine must not be less than 18
mm in thickness and can be hinged on
either the right or left. For the sake of
practicality when using the machine, we
recommend that the panel be hinged on
the same side as the door for the machine
itself - the left.
A
B
C
D
E
Tur seite
Door Mounting Accessories (Fig. 1-2-3-4-5).
Fig. 1
N° 2 Hinges
N° 1 Magnet N° 1 Magnet plate
N° 1 Rubber plug
N° 2 Hinge Supports
Fig. 2
Fig. 3 Fig. 4
Fig. 5
Fig. 4/B
- No. 6 type A self-threading screws, l =13 mm.
- No. 2 type B metric, countersunk screws, l
=25; for fastening the magnet plate to the
cabinet.
- No. 4 type C metric screws, l =15 mm; for
mounting the hinge supports to the cabinet.
- No. 4 type D metric screws, l =7 mm; for
mounting the hinges on the supports.
Mounting the Parts onto the Face of the
Machine.
- Fit the hinge supports to the appliance
front panel, positioning the hole marked with
an arrow in fig. 1 so that it is on the inner
side of the front panel. Fit a spacer (fig. 4/B)
between the surfaces using type C screws.
- Fit the magnet plate at the top of the
opposite side, using type B screws to fix two
spacers (fig. 4/B) between the plate and the
surface.
N° 4 Spacers