Filter
Top Products
6 7
Instructions for Use
1. Remove the water tank from the unit by grasping the handle and
turn upside down. Unscrew the cap from the bottom of the water
tank. Hold the tank under cold running water and fill to the
desired level (Fig. 5). DO NOT fill past the 40 min. fill line. When
you have finished filling the tank screw the cap back on and turn
over (Fig. 6). Place water tank back into unit and make sure it is
sitting properly & securely in the cavity. NOTE: Only fill the water
tank with cold water, DO NOT use HOT water.
2. Plug the steamer cord into a 120V AC electrical outlet.
3. Turn the On/Off switch to the On position. The switch will light to
indicate that the garment steamer is on. Steam will emit in 45
seconds from the nozzle.
4. This unit has a reset button (Fig. 9). When the unit runs out of
water it will automatically shut-off to ensure safe use and a red
indicator light will come on (above reset button). If you wish to
continue your steaming session:
• Turn On/Off switch to “Off” position
• Remove and refill water tank by following step 1 under
Instructions for Use
• Push the reset button on side of unit
• Turn On/Off switch to “On” position
5. When you are finished with your steaming session place the
On/Off switch in the Off position and remove the plug from the
outlet.
NOTE: Be cautious when handling until steamer has fully cooled.
Cleaning and Maintenance
1. Allow the steamer to cool for at least 30 minutes.
2. Empty any excess water from the water tank and allow it to air dry
before replacing the cap and setting it back in the unit.
3. Empty excess water from the reservoir by removing the drain plug
(Fig. 7) and tipping unit.
Storing
1. Open the 3 clips (Fig. 2) on the telescopic pole and glide it slowly
to collapse being careful not to pinch your fingers. When it is all
the way down close the 3 clips back into place.
2. Coil the hose and place on the hanger attachment (Fig. 8)
3. Store in a cool, dry place.
NOTE: Do not wrap the power cord around the unit.
Handle
Hose
Hose Connector
Steamer Nozzle
Hanger Attachment
Pole
Pole Connector
Water Tank
On/Off Switch
Indicator Light
& Reset Button
Figure 6
Figure 7
Figure 8
Figure 9
Figure 5
PS-200C 1/27/05 10:32 AM Page 7