Filter
Top Products
5
Before First Use
• Use ordinary tap water. If you have extremely hard water,
alternate between tap water and distilled water for use in
travel iron/steamer.
• During first use of travel iron/steamer, it may appear to smoke.
This will stop and does not indicate a defect or hazard.
• Many irons/steamers spit or sputter during the first few
uses with tap water. This happens as the steam chamber
becomes conditioned. This will stop after a few uses.
• Steam vents should be cleared before first use. Prepare
travel iron/steamer for steam ironing, then iron over an old
cloth for a few minutes while pressing the steam button.
1. Brush Attachment
2. Steam Brush
3. Lint Pad
4. Brush Attachment
Lock
5. Brush Attachment Grips
6. Dual Voltage Switch
7. Handle/Water Tank
8. Handle Release/Lock
9. Steam Button
10. Water Tank Plug
11. Temperature Control Dial
12. Power Light
13. Travel iron/steamer Soleplate
Water Cup and Storage Bag not shown.
Make sure the unit is unplugged. Insert small screwdriver or
plug blade into the slot on the dual voltage selector switch
and rotate as follows:
• For 120 volts: switch should be turned to the right
(clockwise).
• For 240 volts: switch should be turned to the left
(counterclockwise). If using 240 volts, you must use
an appropriate adapter plug.
NOTE: Damage to unit and garments may occur if unit is
operated at 240V with switch set to 120V.
4
Parts and Features
To Dry Iron
1. With travel iron/steamer unplugged, press Handle Release
Button and rotate handle 180 degrees until it locks and is
parallel or “in line” with travel iron/steamer body.
2. Make sure dual voltage selector switch is set to correct
voltage and then plug travel iron/steamer into power supply.
3. Turn Temperature Control Dial to
desired temperature. With travel iron/
steamer resting on side position, allow
three minutes for travel iron/steamer to
reach desired temperature. Do not pre-
heat travel iron/steamer with soleplate
facing down.
4. To turn travel iron/steamer off, turn
Temperature Control Dial to OFF (O).
5. Unplug travel iron/steamer. Allow to cool completely
before returning handle to storage position and placing
travel iron/steamer in storage bag.
To Change Voltage
840124300 ENv02.qxd 3/16/04 9:28 AM Page 4